Oxford welders with welding tips: Stick Welding — If you learned to weld years ago, you likely learned using an arc welder. Stick welding for many years has been the most popular method for most home-shop welding needs. This process uses an electric current flowing from a gap between the metal and the welding stick, also known as an arc-welding electrode. Stick welding is an effective method for welding most alloys or joints and can be used indoors and outdoors or in drafty areas. It’s also the most economical welding method and provides the ability to create an effective bond on rusty or dirty metals. However, this method is limited to metals no thinner than 18-gauge, requires frequent rod changing, emits significant spatter and requires that welds be cleaned upon completion. Stick welding is also more difficult to learn and use, particularly the ability to strike and maintain an arc. Arc welders are available in AC, DC or AC/DC, with AC being the most economical. It’s used for welding thicker metals of 1/16 inch or greater. These machines are a good choice for farmers, hobbyists and home maintenance chores.
So whats the drawback of OXFORD HYBRID technology? These are a quality British made product so they may be a little more expensive than a cheap imported machine, but are more reasonably priced than other quality offerings from Europe or the US. The other thing to consider is portability; our OXFORD models are maybe not quite as portable as a very small inverter, but are much more portable than an old type machine. From a size & weight point they sit midway between old school machines & the smallest inverter. So the only slight compromise is an increase in weight over a small inverter. Unless portability is number one priority then our OXFORD machines are the wise choice for a quality high performance machine that will keep welding year after year. Find extra info at Oxford Mig Welders.
Should the electrode accidentally touch the metal or the filler, the electrode often becomes contaminated – meaning some of the rod or base metal gets stuck to it. Once the electrode is contaminated, the arc cone becomes misshapen, making it difficult or impossible to aim the arc with precision, and the boiling contaminants on the electrode may spit out impurities, further compounding your problems. The angle between the torch and the base metal is important, too. You need to angle the torch slightly to see the puddle, and provide access for the filler rod. A 15-degree angle is a good starting place, although some welders prefer a bit more or less. If you hold the torch at 45 degrees (or more), you’re losing a lot of the coverage from shielding gas, and the flatter angle will make the puddle longer than it is wide. For the record, the torch is tipped with the electrode pointing forward, in the direction of motion.
Eliminate Any Extra Welds from the Design: Look for ways to modify product designs to eliminate unnecessary welds. For example, one company that manufactured boxes originally had a design that called for welded lift handles on each side of the box. By simply changing the design of the box to cut out lifting slots, it eliminated the need for welding the handles – saving time and money. In another instance, rather than making a part with an open corner, the design was changed to accommodate a closed corner, which meant 1/3 less metal required to fill the corner. Look for Items That Can Be Welded Rather Than Cast: We’ve already discussed ways to eliminate welds to create efficiencies, but what about adding welds? In some cases, it may be more cost effective to weld metal pieces to a part rather than cast the entire component in a costly alloy or exotic metal. For example, a company that originally used a part cast in a high-nickel alloy found that 50 percent of the part could be composed of standard, structural steel which allowed a savings in material and thus a savings in total cost. Also, the company was further able to redesign the part so that it was more efficient. See a few extra info at www.weldingsuppliesdirect.co.uk.